Step 1. First and importantly, make sure your Samsung galaxy s5 is power off.
Step 2. Take off the back cover and remove the battery.
Step 3. Remove the MicroSD and SIM Card.
Step 4. Remove the rear screws
Step 5. Use a plastic opening tool to pry up the plastic midframe connector panel.
Remove the connector panel with a pair of tweezers.
Step 6. Use the sharp tip of a spudger to pry the home button cable connector straight up off its socket.
Now it is time to do the main and difficult process-remove the lcd and glass from the middle frame on your Samsung galaxy s5.
Pre: we strongly recommend the professional teardown tech.
Step 7. Remove the display assembly, we know there is adhesive between the display assembly and rear panel. So we should be careful to deal with these parts.
We'd better use the heating tool to heat the display properly first, such as iOpener heating.
Then use the Plastic opening pry pick to separate the adhesive securing the front panel glass. Only pry where directed. If you experience resistance, stop sliding the opening pick and reapply heat.
Attention:
I.The adhesive securing the top of the phone is only a narrow strip above the earpiece speaker. Slide the pick along the top of the speaker to avoid damaging internal components.
Slide the opening pick across the top of the phone, being very careful not to insert the pick too deeply.
II. If the front panel is not easily freed, the adhesive on the soft button cable may need to be separated.
These cables are thin and easily damaged, therefore be certain you are only peeling them off the display assembly and not lacerating them.
Insert an opening pick under the soft button icons on the display and pry the button cables down off the inside of the front panel.
III. Slightly lift, but do not remove, the home button end of display assembly.
Do not remove the front panel entirely. It is still attached by a connector.
IV. Use the sharp tip of a spudger to lift the front panel assembly cable connector straight up off its socket on the motherboard.
Safely remove the front panel assembly from phone.
Step 8. Take dwon the home button flex cable, it is an easy way to use a plastic opening pry.
Step 9. Remove the screws which connect the middle frame and mother board panel.
Step 10. Separate the middle frame and mother board panel.
Finally, you finish the middle frame tear down for Samsung galaxy s5.
In this way, you can reinstall these parts.
Pre: Reinstalling your display will most likely require a fresh set of adhesive.
Now let's list the repair tools during these processes.
Plastic opening pry
Plastic opening pry stick
Spudger
Cross Head Screwdriver
No comments:
Post a Comment