Most people always think it is hard to do the cell phone repairing
by themselves with
cell phone replacement repair parts,
especially cell phone front screen glass. Recently Hytparts store
have already provided
Samsung Galaxy s5 replacement parts, so
some clients asked me how to replace the Samsung galaxy s5
front screen glass, it looked hard to make it, and so did I.
After I saw the processes of front glass replacing at iFixit, I know
it is not that hard to make it. And maybe it is easy and
convenient to finish it by ourselves. Don't believe it, come on and
have a see.
Remove the rear case by using moderate force to pry the divot on
the left of the rear facing camera with a plastic opening tool or
your fingernail.
Continue to lift the case, working your way around the perimeter
until the entire rear cover is removed.
Lift the battery upward with your finger or plastic opening tool by
pushing on the notch located on the bottom of the battery.
Remove the battery from the phone.
Gently slide out the SD card using your fingernail or a plastic
opening tool.
For reassembly, gently slide in the microSD card until it stops.
Removing the screen will cause your device to be less water
proof.
There are many ways to remove the adhesive from the screen.
You could use a heatgun, blow dryer, or the iOpener. We used an
iOpener.
We recommend that you clean your microwave before proceeding,
as any nasty gunk on the bottom may end up stuck to the
iOpener.
Place the iOpener in the center of the microwave.
For carousel microwaves: Make sure the plate spins freely, if your
iOpener gets stuck it may overheat and burn.
If you have not used your iOpener for some time, or this is the
first time you are using the iOpener, microwave it wrapped in a
damp paper towel. This will prevent it from burning if it is
overheated.
Heat the iOpener for one minute on the highest power setting.
Be careful not to overheat the iOpener during the repair
procedure. Wait at least two minutes before reheating the
iOpener.
The bag will be very hot, so be careful when handling it. Use an
oven mitt if necessary.
Remove the iOpener from the microwave, holding it by the
printed tag.
Throughout this procedure you may need to reheat the iOpener.
To prevent overheating the iOpener, always wait at least two
minutes before microwaving again. Do not microwave the iOpener
for more than one minute at a time.
Lay the iOpener flat on the bottom of the device, directly over
the home button. Smooth the iOpener along the surface to
ensure good contact with the device. Leave the bag on the device
for around 90 seconds.
Repeat the process laying the bag on the left and right edge of
the screen.
Use a light amount of force when removing the screen.
A black ribbon cable attaching the display to the motherboard
and a black cable attaching the home button to the motherboard
will be damaged if you force the screen off.
Starting at the top of the device, work the plastic opening tool
under the screen. The top of the device has the Samsung logo
and headphone port.
Start separating the screen from the glue. Work your way around
the screen until the glue is no longer holding the screen in place.
The screen will not come off completely yet, there are still cables
attaching it to the phone.
Then the new
Original Front Screen Outer Glass Lens Replacement for Samsung Galaxy S5 finally is used for your S5,
and return you a new S5 screen. Importantly you can save more
money on your cell phone fixing.
 |
| Original Front Screen Outer Glass Lens Replacement for Samsung Galaxy S5 |
So never give up what you want to do because things looks
difficult to do, after you do, you may find it is only difficult at
your mind. In fact, it is easy to make it.
